Ezwebcon Configuration; Getting Started; Incoming Logins - Oki B6100 Installation Manual

NOTE: 1. Only available as a menu selection if an IPDS option is installed in the printer.
2. Always available as a menu selection.
3. If AUTO SWITCH is selected the FORMAT selection will automatically be RAW.
4. This is the MAC—the factory-set network address.
5. This is a free format entry that requires your input.

Getting Started

It is important to consider the following points before logging into and configuring the NIC:
• The NIC's IP address must be configured before any TCP/IP functionality is available.
the IP Address" on page 2-11.
• There are two important passwords on the NIC: the privileged password and the login password.
Changing any server, service, or port setting requires privileged user status. The default privileged password
is system.
The login password is required for remote console logins. The default login password is access.
NOTE: If you would like to change either the privileged or login password, use EZWebCon.

EZWebCon Configuration

The EZWebCon configuration software is the recommended way to configure the NIC. EZWebCon is a
graphical user interface which guides first time users through the initial configuration process and allows
experienced users to update and change any configurable parameters.
The EZWebCon software is located on the CD-ROM that came with your printer and is installed from the
Menu Installer. For assistance once EZWebCon is running, refer to the EZWebCon on-line help.

Incoming Logins

Incoming logins made via EZWebCon can be used to configure the server. Incoming LAT and TCP/IP log-
ins can also be made using LAT and TCP/IP commands.
Incoming Telnet connections are enabled by default. To change this setting, use the Define Server Incom-
ing command.
DEFAULT
DEFAULT
Ethernet Network Interface Card Configuration Guide
NETWORK FRAME
AUTO SENSE
802.3
ETHERNET II
802.2 SNAP
802.2
AUTO SENSE
QUEUE SCAN RATE
1 - 255
1
2-5
See "Setting