Troubleshooting; About Troubleshooting; Power On Problems - Oki B6100 User Manual

TROUBLESHOOTING

ABOUT TROUBLESHOOTING

This section provides procedures to identify and solve problems that may occur while you are
setting up and installing the printer.

POWER ON PROBLEMS

If you have problems turning on the printer, check the possible causes listed in the table
below. If the printer will not start after checking these items, turn the printer off, disconnect
the power cord from the AC outlet, and contact your dealer or an authorized service provider.
Description
There is no power.
Power is frequently
interrupted.
Possible Cause
The power switch is not set to
[ I ] (on).
The power cord is not properly
plugged into an AC outlet or into
the AC connector on the rear of
the printer.
Voltage of the AC power is not
correct.
The fuse on the power cord is
not functioning. (UK only)
The AC wall outlet is not
functioning.
There is interference from other
electrical devices on the same
circuit.
Thermal sensors may have shut
down the printer.
The printer is malfunctioning.
Action
Check the power switch.
Set the power switch to [ O ] (off).
Then, connect the power cord firmly to
the AC connector and to the AC outlet.
Verify that the AC outlet is rated for the
voltage of your printer.
Verify that the fuse on the power cord
is intact. (UK only)
Verify that voltage is present at the AC
wall outlet by connecting another
electrical device to the outlet. If power
does not flow to the other device,
check the AC wall outlet circuit
breakers for a tripped breaker.
Unplug all electrical devices from the
AC wall outlet circuit, and then
reconnect only the printer. Turn printer
power on.
Turn the printer off. Wait 20 minutes.
Then, turn the printer back on.
Turn the printer off. Disconnect the
power cord from the AC outlet. Contact
your dealer or an authorized service
provider.
User's Guide
29