Connecting Wires To Terminals - Kenwood KDC-MP246 Instruction Manual

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo type
and does not have any resistance.
Front side
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control (Blue/White)
Motor antenna control wire (Blue)
Steering remote control
(Light Blue/Yellow)
Mute control wire (Brown)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Montreal Saunas
R
Fuse (10A)
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
P.CONT
terminal.
Depending on what antenna you are using, connect either to the control
ANT.
terminal of the motor antenna, or to the power terminal for the booster
CONT
amplifier of the film or short pole-type antenna.
To use the steering wheel remote control feature, you need to an
REMOTE
exclusive remote adapter (not supplied) matches your car is required.
CONT
(KDC-MP246/KDC-MP3046 only)
STEERING
WHEEL
REMOTE
INPUT
Connect to the terminal that is grounded when either the telephone rings
or during conversation.
MUTE
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
Car fuse box
ACC
L
FM/AM antenna input
Rear output/ Sub Woofer output
(KDC-MP246/KDC-MP146/KDC-MP3046/
KDC-MP2046 only)
Ignition key switch
Car fuse box
(Main fuse)
Battery
17
|
English