Washing The Dishes; Aqua Sensor; Switching On The Appliance; Optical Display While The Programme Is Running - Bosch 9000416647(8811) Instructions For Use Manual

aus

Washing the dishes

Aqua sensor *

* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted
to the degree of soiling.

Switching on the appliance

Turn on the tap fully.
Open the door.
Switch on ON/OFF switch
The display of the last selected
programme flashes. This programme
remains selected if no other programme
button is pressed.
2
The expected programme duration
flashes on the digital display
Press the START button
Close the door.
The programme starts running.
14
Optical display while the
programme is running *
* depending on model
While the programme is running,
a light spot shines on the floor under
the appliance door. Do not open the
dishwasher door until the light point
is no longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point
is not visible.
This function can be changed as follows:
.
1
To change the setting:
.
8
.
7

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
on the digital display
Release both buttons.
Press programme button A until
the factory set value
on the digital display
By pressing the C button, you can
switch the function off
Press START button
The set value is saved.
Close the door.
.
1
until
7
is indicated.
is indicated
.
8
or on .
.
7
.
8