Craftsman 917.288623 Operator's Manual page 11

The operation of any tractor can result in foreign objects thrown into
the eyes, which can result in severe eye damage. Always wear safety
glasses or eye shields while operating your tractor or performing any
adjustments or repairs. We recommend standard safety glasses or a
wide vision safety mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operatorto leave
the seat without first setting the parking brake
will shut offthe engine.
1. Depress clutch/brake pedal (B) all the
way down and hold.
2. Pull parking brake lever (C) up and hold,
release pressure from clutch!brake pedal
(B),then release parking brakelever. Ped-
alshould remain inbrake position, Ensure
parking brake will hold tractor secure.
STOPPING
MOWER BLADES -
• To stop mower blades, move attachment
clutch control to disengaged position (r_).
NOTE: Failure to move throttle control be-
tween half and full speed (fast) position, be-
fore stopping, may causeengine to "backfire".
• Turn ignition key (F) to "STOP" position
and remove key. Always remove key when
leavingtractor to prevent unauthorized use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch in
any position other than "STOP" will causethe
battery to discharge and go dead.
NOTE: Under certain conditions when tractor
is standing idle with the engine running, hot
engine exhaust gases may cause "brown-
ing" of grass. To eliminate this possibility,
always stop engine when stopping tractor
on grass areas.
CAUTION: Always stop tractor com-
pletely, as described above, before leaving
the operator's position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast).
• Operating engine at less than full speed
(fast) reducesengine's operating efficiency.
• Full speed (fast) offers the best mower
performance.
(__) Attachment (1_) Attachment
Clutch Control Clutch Control
"Engaged" "Disengaged"
GROUND DRIVE -
• Tostop ground drive, depress brake pedal
all the way down,
• Move motion control leverto neutral posi-
tion.
ENGINE -
• Movethrottlecontrol (D) between half and
full speed (fast) position.
11