Jenn-Air WM236 Use And Care Manual page 27

Other Hints on
Caring for Your Oven
Cleaning Other Surfaces of Your Oven
Door and control panel trim: The metal trim around the door and the control
panel can be cleaned with any nonabrasive cleansers such as Bon-Ami or soapy water; rinse
well. Be careful not to use an excessive amount of water.
Glass on the control panel front and oven door front: To clean, use
any suitable glass cleaner or soapy water. To prevent moisture from getting behind the glass
control panel, spray a cloth with glass cleaner then wipe the panel.
Control Knobs: The knobs on the control panel can be removed with the controls in
the OFF position. Pull each knob straight from the shaft. Wash knobs in warm soapy water
or dishwasher; do not use abrasive cleansers or materials. To replace each knob, match flat
part of knob opening with the spring on the shaft, returning in OFF position.
Oven Racks
To remove, pull forward to the "stop" position,
lift up on the front of the rack and pull out.
Oven Light Bulb
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker panel. Be
sure that the entire oven cavity including the light bulb is cool before attempting to remove.
To replace light bulb:
1. Carefully remove the glass light lens and lens retainer
by removing the two screws in the light lens retainer
using a phillips screwdriver. Note: The light lens is
separate from the light lens retainer. The two pieces will
drop down into your hands at the same time. Oo NOT
remove the remaining two screws.
2. To obtain firm grasp on bulb, wear protective rubber
gloves. Remove by turning bulb to the left. Do not touch
a hot oven light bulb with a damp cloth as bulb will break.
Note: If the bulb does break and you wish to remove
it, be certain power supply is disconnected and wear
protective gloves. You may contact your authorized Jenn-
Air Service Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance bulb.
Bulb with brass base is recommended to prevent fusing
of bulb into socket.
4. Place light lens inside of light lens retainer. Holding the
light lens and lens retainer in place, insert the two screws
into the light lens retainer and tighten.
28