Jenn-Air WM236 Use And Care Manual page 10

7. Push ENTER button to enter stop time.
The indicator word AUTO will blink in the Display Window. When start time
is reached, the indicator word AUTO will remain in Display Window. The BAKE
indicator light will glow until the desired temperature is reached.
When stop time is reached, the oven shuts off and the indicator word AUTO will
begin to blink and timer will beep. Beeping will continue every 10 seconds for 15
minutes unless the CANCEL button is pushed twice.
To check ST,U{T TIME before Cooking begins:
Hold in START TIME
button until the words START TIME appear in the Display Window. The start time will
be displayed briefly, then Display will return to time of day.
To change START TL_IIE before cooking begins:
1. Hold in START TIME button until the words START TIME appear in the Display
Window.
2. Turn SET dial to desired time.
3. Push ENTER button twice to enter new start time and stop time previously
programmed.
To check STOP TIME: Hold in STOP TIME button until the words STOP TIME
appear in the Display Window. The stop time will be displayed briefly, then Display will
return to on-going program.
To change STOP TIME:
1. Hold in STOP TIME button until the words STOP TIME appear in the Display
Window.
2. Turn SET dial to desired time.
3. Push ENTER button to enter stop time.
To Cancel function programmed: Push CANCEL button twice to cancel func-
tion, during programmed time or after time has expired.
NOTE: After clock-controlled baking, turn SELECTOR and TEMPERATURE knobs
to OFF position.
NOTE: Since food continues to cook if left in the oven, it is suggested that the clock
controls be used primarily to start the oven when no one is in the kitchen.
Provisions should be made to have the food removed as soon as the signal has
sounded.
NOTE: If more than 7 seconds elapses between holding in START TIME button
or STOP TIME button and turning the SET dial, the display window will
automatically return to on-going program.
NOTE: If more than 1 minute elapses between turning SET dial to a new time and
entering new START TIME and STOP TIME, the entire program will be
cancelled and display will return to time of day clock.
11