LG LDG3037ST Owner's Manual page 46

46 BEFORE REQUESTING SERVICE
Symptoms and Questions ...... Possible CaUse/Solution
Too much smoke during the setf clean cycle.
The oven door does not open after a self clean cycle.
The oven door is not clean after a setf clean cycle.
"CLOSE DOOR TO CONTINUE BROILING" or "DOOR
OPENED" appears in the display.
"DOOR LOCKED" message appears when you want to cook.
Oven control beeps and displays an F error code.
The oven racks were cleaned in a self clean cycle.
Clock is flashing.
"Burning" or "oily" odor emitting from the vent.
Strong odor.
Fan noise
Convection fan not working.
Burners are not lighting properly after cleaning the cooktop
surface.
When lighting just one burner, clicking noise is heard from
all the burners.
PF(Power Failure) displayed
Display Time is flashing
Too much soil in the oven. Open the windows to get rid of the
Lower
smoke from the room. Press
the
oLEUpp_[_FF or CLEAR/0FF key. Wait un-
til the @ light goes off before trying to open the oven door. Wipe
up the excess soil and reset the clean cycle.
The oven temperature is too high. Wait up to one hour to cool
down.
• Incorrect oven control settings. See "Self Clean" in the Care
and Cleaning section.
• The oven was heavily soiled. Clean up heavy spills before
beginning the self clean cycle. Heavily soiled ovens may need
either a longer self clean or two setf clean cycles.
Close the oven door.
The oven door is locked because the temperature inside of the
_. Upper Lower
oven istoo high,_'ress me CLEAR/OFF
orCLEAR/OFF key,
Press the c , # #%F or
Lower
CLEAR/OFF key and wait for one hour.
Check the main gas shut-off valve or the oven gas shut-off
valve and call for service.
Remove the power from the range for five minutes and then
reconnect the power. If the function error code repeats, call for
service.
Apply a small amount of vegetable oil to a paper towel and wipe
the edges of the oven racks. Do not use lubricant sprays.
Power outage or surge. Reset the clock. If the oven was in use,
. . Upper Lower
you must reset it by pressing the CLEAR/0FF or CLEAR/0FF key. Reset
the clock and any cooking function.
This is normal in a new oven. To speed the process, set a self
clean cycle for a minimum of three hours. See "Self Clean" in the
Care and Cleaning section.
An odor from the insulation around the inside of the oven is nor-
real for the first few times the oven is used.
The convection fan may turn on and off automatically.
This is normal.
The preheating temperature has not been reached. The Fan will
start automatically once the preheating temperature is reached.
Make sure that the burner heads and caps are completely dry and
properly positioned.
This is normal. Electric spark igniters from the burners cause the
clicking noise. All the spark igniters on the cooktop will activate
when igniting just one burner.
Depending on the model of your range, the display will either
show "PF" or a flashing clock. This means that the product has
just been plugged in, or that it has experienced a power interrup-
tion. To clear the "PF" message, press the "CLEAR/OFF" key
on the oven controis. If your oven displays a flashing clock, then
press the "Clock" key and reset the time, or press any key to
stop flashing.