Furuno 841 MARK-2 Operator's Manual page 45

Connections
Connect the signal and power cables, the
ground wire and optional equipment as shown
in Figure 5-12.
Power cable connector
Connect power
cable here.
Signal cable connector
Connect signal cable
from antenna here.
CAUTION
Tighten the boot-band
securely to ensure water
tightness.
See the procedure in
below.
Signal cable connection
1. Connect the signal cable to DJ-1 on the rear
panel of the display unit.
Rubber cover
DJ Connector
DJ-1
2. Cover the connector with the rubber cover.
The projection on the connector base is in-
serted into the groove on the rubber cover.
10.2-31.2VDC
1 3 GND
2
Ground terminal
Connect ground wire between
here and ship's ground.
Figure 5-12 Display unit, rear view
Boot-band
Cable
Display unit
RP
HDG
NMEA
OPTION
DJ-1
MARINE RADAR
TYPE
SER.NO.
DATE
COMPASS SAFE DISTANCE
STD M STEER M
EQUPMENT CLASS
FURUNO ELECTRIC CO., LTD
Grasp
Groove
3. Put the boot-band as shown below, and
tighten it.
Covered.
(not use)
HDG connector
Connect heading
sensor nere.
NMEA connector
Connect navaid
nere.
OPTION connector
Connect navaid,
video sounder, etc.
here.
Rubber cover
Grasp
Display unit
Boot-band
Display Unit
33