Kenmore 116.35622 Owner's Manual page 9

Remove the
hose from the Hose
hose clip by
pulling straight
out.
TELESCOPIC WAND WITH
SUCTION CONTROL SLIDE
Crevice
Tool
Remove the
Telescopic
telescopic
Wand
wand
from
its storage
position.
Remove the crevice tool from its storage
position in the wand. Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length. Turn the
locking ring to the LOCK position. Attach
the extension wand onto the open end of
the hose.
Lower_"_ '_ Suction
Wand'-""-_'.,_"_p_ Control Slide
_ Wand _.-_..]
_Unloc_ "_,-<- Upper
Wand
Align the tabs on the extension wand with
the "J" slots in the hose (as illustrated above
right). Push the wand into the hose and
twist to the right to lock.
To achieve maximum
Hose-
reach with the attach-
ments, add the crevice
tool to the end of suction
the wand by Control
inserting and
twisting slightly.
Telescopic
Wand
Toot
"Ra_ed
The dusting
brush or the
combination
brush may be
attached direct-
ly to the wand
or placed on
the end of the
crevice tool.
TO OPERATE SUCTION
CONTROL SLIDE
Telescopic Wand
When using
attachments for \
cleaning Suction
Control
draperies, small S#de
rugs with low pile
and other
delicate items,
twist the suction
control stide to
the open
position. This slide is located on the
telescopic wand, close to the hose.
This will reduce suction for ease of cleaning.
Note: Return suction control slide to the
closed position for normal cleaning.
When using attachments, be careful not
to overextend the stretch hose when
reaching. Trying to reach beyond the
hose stretch capability could cause the
vacuum cleaner to tip over, Make sure the
carpet/bare floor selector is in the bare
floor position. Damage to the floor sur-
face may occur if the carpet setting is
used.
9