Cleaning The Exhaust Duct; Cleaning The Moisture Sensor; Cleaning The Bearing Shield - Bosch V20-UL Operating, Care And Installation Instructions Manual

Cleaning the exhaust
duct
Inspect and clean the exhaust
ducting at least once a year to
prevent clogging. A partially
clogged exhaust can lengthen the
drying time.
1. Switch off the dryer and allow it
to cool down.
2. Pull out power supply plug.
3. Disconnect the duct from the
dryer.
4. Vacuum and reconnect the
duct.
Cleaning the moisture
sensor
Occasionally the moisture sensor
has to be cleaned because a fine
layer of transparent buildup is
deposited on the sensors.
Cleaning the bearing
shield
Over time, fluff from the drying
process collects in the bearing
shield.
This fluff can be easily removed
using your vacuum cleaner, at least
once a month.
This deposit can easily be removed
by wiping the sensors (the two bars
next to the lint filter) with a cloth and
a little white vinegar.
Use white vinegar only!
Clean the moisture sensor once
a month.
18