The Belt - Samsung VAU-5200R Operating Instructions Manual

How to replace the Headlight (VAU-5400)
3-7
Disconnect cleaner from electrical outlet
Using a screwdriver, remove the two
screws as shown and lift off lens.

The belt

The belt on your cleaner causes the
agitator to rotate and is important for
the effective operation of the cleaner.
The belt is located under the bottom
plate of the cleaner and should be
checked from time to time to be sure it
is in good condition.
When to replace
Disconnect cleaner from electrical
outlet.
To check belt, remove bottom plate as
shown in "How to replace." Replace
belt it is stretched, cut or broken.
Part No.
3-12
With lettering on outside of belt and
positioned as shown in box on (D),
slide new belt over motor pulley (B).
3-8
Remove the bulb from the socket by
pushing in gently and turning it
counterclockwise. Install the new bulb
by pushing it gently into the socket and
turning clockwise. You can use any
standard bayonet base vacuum
cleaner lamp rated 125V, 20W.
3-10
How to replace
Disconnect cleaner from electrical
outlet.
Place handle in low position and turn
cleaner over so bottom side is up.
Remove the 4 screws as shown with a
screw driver.
3-13
Insert agitator through belt and place
belt in belt guide (C) on agitator.
Should the agitator shield (D) become
dislodged while replacing the belt or the
agitator, reposition it as shown, noting
the placement of its belt guide (D)
EN
6
3-9
Reposition lens and secure with the
two screws.
3-11
Remove agitator and used belt.
Discard used belt.
3-14
Grasp agitator firmly and fit it into
position by first sliding the end
opposite the belt into the rectangular
slot (F) on side of cleaner.
Pull other side of agitator (G) into
place.
Turn agitator, making sure belt is not
pinched between agitator and agitator
shield.