Replacing Dust Bag; Filter Bag - Samsung VAU-5200R Operating Instructions Manual

Replacing Dust Bag

Disconnect cleaner from electrical outlet.
3-1
Pull the bag door outward to open.
Set bag door aside.
Cleaning secondary and final filters
3-4
How to clean
Disconnect cleaner from electrical
outlet.
The secondary filter (A), located
behind the grill in the bottom of bag
compartment, protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and
lift out filter.
Normal filter (Black)
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter and grill.
3-2
Removing and installing

filter bag

Grasp dust bag collar (A) and pull
collar from tube (B).
Note: Do not clean out old dust bag
and reuse. Discard used dust bag.
Hold new dust bag as shown. Align
opening in dust bag with (B).
Push (A) firmly onto (B).
Tuck in dust bag.
3-5
The final filter asists in the filtration
process to return clean air to the room.
To remove this filter, first open the door
on the side of the cleaner (Fig. 3-6).
Grasp filter (B) and pull it straight out.
Micro filter (VAU-5200)
Reposition new filter by reversing this
procedure.
HEPA filter (VAU-5400)
This filter will become dirty and needs
to be replaced about once a year to
maintain efficient filtration.
Reposition new filter by reversing this
procedure.
Do not operate cleaner without either
the secondary or final filter in place.
EN
5
3-3
Replacing bag door
Reposition bag door by placing tab on
bottom of door into opening (C).
Press top of door to snap securely
shut.
3-6
How to attach filter door
The filter door is designed with a
"break away" feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges (C) of cover
with slots on sides of filter area.
Check agitator shield
Because your cleaner picks up so well,
we strongly recommend you check for
debris accumulation under the agitator
shield each time you clean the filters.
Removing debris under the shield will
help maintain your cleaner's excellent
pick up and suction. Remove debris as
follows:
1. Disconnect cleaner from electrical outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-10),
removing agitator (Fig. 3-11), and
lifting agitator shield (Fig. 3-13).
3. Remove any debris and replace
shield, agitator and bottom plate
(Figs. 3-13 to 3-15).