Kenmore 790.9750 Series Use & Care Manual page 8

Before Setting Surface Controls Cco.t'dl
To Set the Cooktop Lockout Feature cOOKTOP
LOCKOUT
The COOKTOP LOCKOUT pad is used to activate the Cooktop Lockout feature which wiii lock aii surface elements from
being accidentally turned ON. This feature will only loci< the cooktop.
INSTRUCTIONS PRESS DISPLAY
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are
set to
the OFF position.
.
Press and hold for 3 seconds COOl(TOP LOCKOUT _ until two I_
appears in the display (Figure 1). If a triple beep sounds instead, check
all surface elements and turn them to the OFF position and repeat
step. The two _ will appear in the display indicating the cooktop
this
controls and functions are locked out until the cooktop is unlocked.
Whenever the Cooktop Lockout feature is active, " - -" will appear in all
of the surface element display windows.
COOKTOP
LOCKOUT
for 3 seconds
Figure I
To turn the Cooktop Lockout Feature OFF:
1. Press and hold for 3 seconds COOKTOP LOCKOUT I_1 until the two
_ disappears from the This will indicate the
display (Figure 2). cooktop
may be used normally.
COOKTOP
LOCKOUT
for 3 seconds
Figure 2
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop
Lockout feature. The cooktop will remain locked until the Self-Clean cycle
has completed and the oven door has unlocked.
Note: If a power failure occurs after the Cooktop Lockout has been
activated, you must turn OFF the Cooktop Lockout feature before being able
to use the cooktop features again.