Control Pad Functions; For A Silent Control Panel; Temperature Conversion - Kenmore 790.4676 Series Use & Care Manual

Control Pad Functions
Note: The appearance of your oven control may differ slightly from the one illustrated below. However, all functions are
the same. Also, push buttons or pads may be shaped differently than those appearing in this Use and Care Guide.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar
with the various functions of the oven as described below.
CLOCK SET COOK TIME
PAD-- Used to set PAD-- Used
the time of day. to enter the
_ length of the
OVEN INTERIO _aking
LIGHT PAD-- Used
to turn oven interior
light ON or OFF.
SELECT CLEAN PAD--
Used to select the Self-
UP and DOWN ARROW PADS-- Used
along with the function pads to select oven
temperature, cool< time, start time (when
programming an automatic start time), time
of day, clean time and minute timer.
o
i Cook
Time
BAKE PAD-- FEATURE INDICATOR
Used to select LIGHTS-- These light
the bake to show which feature
function, is in use.
BROIL PAD--
Used to select
the variable broil
function.
WARM & HOLD
PAD-- Used to
Cleaning cycle. A 2, 3 _set the Warm &
or 4 hour Self-Clean • o e • OVEN A oJ Hold feature.
time may be selected. --S_el_t
I sTeltm(_rff I Dtal_Y • PREHEAT _ /f__
/ ? DOOR LOCKED _
_'SToOw_N__ STseOdPtPoAc?e-a-r any
TIMER SET/OFF PAD-- Used to / I__
set or cancel the minute timer. / I ........ _funchon" "
previously
The minute timer does not start / OVEN, PREHEAT & DOOR LOCKED LIGHTS _ -- The entered except
or sto- cool<in- Also it is used t-,// "OVEN" light will glow each time the oven turns on to the time of day
P 9" , v • • n n • • •
set the Continuous Bake feature / maintain the set
oven temperature.
The PREHEAT hght and minute tlmer.
"/ will glow when the oven is first set to operate, or if the Press STOP to
/
DELAY START PAD-- Used to set desi _ ' "red temperature is reset higher than the actual oven stop cooking. Also
the desired start time for baking & temperature. The "DOOR LOCKED" light will flash when the STOP pad is
Self-Clean. May be used with COOK the oven door locks and unlocks or when using the Self- used to activate
TIME to program a delayed bake Clean cycle or when the oven door lockout is activated. The oven door lockout
cycle, indicator light will glow constantly after the door locks, setting.
_Note: The OVEN indicator light on the electronic display will turn ON and OFF when using the Bake feature and during
preheat. This is normal and indicates that the oven is cycling to maintain the selected baking temperature. When the preheat
indicator light turns OFF, your oven has reached the set temperature.
For a silent control panel
When choosing a function, a beep will be heard each time a pad is pressed. If desired, the control can be programmed
for silent operation. Press and hold pad. After 5 seconds, the control will beep once. This will block the controls from
sounding when a pad is pressed. To return to normal sound operation, press and hold pad again for 5 seconds until
the control beeps once.
Temperature conversion
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed
for any temperature from 170°F to 550°F (77°C to 287°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
1. Press pad. " " appears in the display.
2. Press and hold the A pad until "HI" appears in the display.
3. Press and hold pad until °F or °C appears in the display.
4. Press the A or V pad to change °F to °C or °C to °F.
5. Press any control pad to return to normal operating mode.
11