Rear Panel Connector Descriptions - Agilent Technologies 7000B Series User Manual

1 Getting Started

Rear Panel Connector Descriptions

1. External Trigger Input
explanation of this feature.
2. Trigger Output
3. 10 MHz Reference Connector
page 388.
4. Calibration Protect Switch
5. Digital Input Connector
(MSO models only).
6. XGA Video Output
on the rear panel.
You can connect an external monitor to provide a larger display or to
provide a display at a viewing position away from the oscilloscope.
The oscilloscope's built- in display remains on even when an external
display is connected. The video output connector is always active.
For optimal video quality and performance, we recommend you use a
shielded video cable with ferrite cores.
7. USB Host Port
the front panel. USB Host Port is used for saving data from the
oscilloscope and loading software updates. See also
8. USB Device Port
PC. You can issue remote commands from a host PC to the oscilloscope
via the USB device port. See
Libraries"
9. LAN Port
Remote Front Panel feature using the LAN port. See
page 239 and
44
See "External Trigger Input"
See "Trigger Types"
See
Connect the digital probe cable to this connector
A standard XGA video output connector is provided
This port functions identically to the USB host port on
This port is for connecting the oscilloscope to a host
on page 249.
You can communicate with the oscilloscope and use the
"Accessing the Web Interface"
InfiniiVision 7000B Series Oscilloscopes User's Guide
on page 112.
See "To set the reference signal mode"
"To perform user calibration"
"Remote Programming with Agilent IO
on page 244.
on page 109 for an
on
on page 397.
page 37.
"Web Interface" on