Kenmore One-Speed Automatic Washers Owner's Manual & Installation Instructions page 32

Most laundering problems are easily solved if you understand the cause.
Check these lists for common laundry and washer problems, If you need
further assistance, see the back page,
Problem Possible Cause Solution
Washer Leaks Household plumbing is leaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses (see "INSTALLATION
Sections D & E).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLATION,"
Section D),
Drain hose not propedy Clamp drain hose
clamped or is off. (see "INSTALLATION,"
Section C),
Drain is clogged, Remove drain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gaI (64 L) of water per minute.
Tab moved forward during Ensure tub is centered before
unloading, causing water to starting washer.
deflect off tub ring.
Unit not level causing water Ensure front feet are installed and
to deflect off tub ring. nuts are tightened. Level washer.
Reset rear legs
(see "INSTALLATION,"
Section G).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off load,
Washer is ovedoaded. Fills or Reduce load size.
spray rinses are deflecting off
load.
Won't Drain/ Drain hose is kinked or Straighten or unplug hose
Won't Spin/ clogged. (see "INSTALLATION," Section C).
Wet Loads
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than Lower drain hose
96 in (2,4 m) above floor. (see "INSTALLATION," Section A).
Too much detergent - Use less detergent.
excessive sudsing.
Wrong cycle for load
being washed.
Choose a cycle with a higher spin
speed (see "Operating Your Washer")
32