Mounting The Camera; Connecting Cables Through The Housing Base - Honeywell HD4DX User Manual

Mounting the Camera

The HD4D Camera is designed to be surface mounted on a wall or ceiling. Before you
mount the camera, use the mounting template provided to mark and pre-drill the holes.

Connecting Cables Through the Housing Base

For installations requiring pulling cables through the grommet located in the bottom of the
base:
Use a sharp knife to cut an ! opening in the base gasket (see the figure below). Be
1.
careful. The opening should only be big enough to feed the cable assembly through.
2. Pull the cabling through the opening.
3. Apply appropriate sealant around the opening to prevent moisture from entering the
housing.
8
!
Base gasket opening