Adjusting the Camera
To adjust the HD4D Camera:
1.
Apply 12 VDC or 24 VAC power to the camera and monitor the video signal.
2.
Loosen the screws that lock the gimbal assembly in place (see
3.
Adjust the camera carrier to the desired view.
4.
Tighten the screws to lock the gimbal assembly in place.
Note
Orient the camera as shown in
orientation.
Figure 5
Top view
Locking screw. Loosen to
adjust Horizontal (B).
Set focal length
Line Lock switch
(bottom)
must be left in
ON position.
Document 800-00023 Rev D
05/07
Gimbal Adjustment
Locking screw
Set focus
(top)
Figure 5
to maintain the correct picture
C
Figure
5).
Angle view
Setscrews (x2). Loosen to
adjust Pan (C). Other
setscrew located on
opposite side.
B
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
A
13