Initializing A Hdd - Samsung SVS-5R User Manual

3.2

Initializing a HDD

The SVS-5R shows the status of the RAID operation and connected SATA hard drives through
an LCD on the front panel.
※Caution: The SVS-5R is initially set up to "RAID5 4d".
Should connected SATA drive fail, the front LCD indicates the degraded status of the SVS-5R.
In this case, you can rebuild the RAID array by replacing the failed SATA hard drive.
- Using the enclosed access panel lock, open the right front panel, and then press the power
switch on the front panel for at least 2 seconds to turn on the SVS-5R.
- When the SVS-5R turns on, the front LCD displays a message as shown below. The SVS-5R
is initially set up to "RAID5 4d." To use 4 SATA hard drives for RAID5, please wait for 20
seconds after turning it on. To use a different RAID mode, please refer to 4-1.RAID Settings.
Power Switch