Sequence Line - D-Link DCS-6915 User Manual

20x full hd high speed dome network camera

Hide thumbs Also See for DCS-6915:

Table of Contents

Section 3: Advanced Configuration

The Network Camera supports eight Sequence Lines; each Sequence Line consists of up to

64 Preset Points.

Note: Before setting this function, users must pre-define at least two Preset Points.

Sequence Setting

Click on the Edit button in Sequence Setting section to enter the Sequence setting menu.

Sequence Line: Select the number of the Sequence Line to be set from the drop-down list in

the top of the Sequence setting menu.

Sequential Preset Points Setting:

1. Specify a path number to use.

2. Specify up to 64 point numbers using the Prev Page and Next Page buttons to navigate

between the sequence preset numbers:

a. Select a preset point from the Preset List.

b. Specify the Dwell Time.

c. Specify the Camera Speed.

3. Repeat steps a,b, and c, for up to 64 points.

Sequence Run

Select the specified Sequence Line from the drop-down list, click on the Go button, and then

the camera will start moving forward each scene sequentially as programmed. To view the

camera executing a Sequence Line in full screen mode, please move the cursor onto the live

view pane, right-click select fullscreen. To stop running the Sequence Line, simply move the

cursor to the live view pane and move the camera in any direction.

D-Link DCS-6915 User Manual

Sequence Line

Table of Contents