Before Commencing Operation - Sanyo MPR-311D(H) Instruction Manual

BEFORE COMMENCING OPERATION
Installation site
To operate this unit property and to obtain maximum performance, install the unit in a location with the following
conditions.
<D
A location not subjected to direct sunlight
Installation in a location subjected to direct sunlight
may lead· to inadequate cooling.
®
A location with adequate ventilation
Leave at least 10cm around the unit for ventilation.
Poor ventilation result in a reduction of the refrigeration
capability.
@ A location far from heat generating sources
Avoid installing the unit near heat-emitting appliances
such as gas ranges or stoves. Heat can cause.
inefficient refrigeration.
@ A location with a sturdy and level floor
&'WARNING
o
Be sure to install the unit on a sturdy floor.
If
the floor is not strong enough or the
installation site is not adequate, this may
result in injury from the unit falling or tipping
over.
~CAUTION
o
Select a level and sturdy floor for
installation. This precaution prevents the
unit from tipping.
Improper installation
may result in water spillage or injury from
the unit tipping over.
Install the unit on a sturdy floor to avoid vibration
and noise. Placing the unit on an unsteady floor
will cause vibration and noise.
8
@ A location not prone to high humidity
&'WARNING
' " Do not use the unit outdoors. Current
\.Y
leakage or electric shock may result if the
unit is exposed to rainwater.
' " Never install the unit in a humid place or a
\.Y
place where it is likely to be splashed by
water. Deterioration of the insulation may
resultwhich could cause current leakage or
electric shock.
' " Do not install the unit under the piping for
\.Y
water main and lor vapor. Deterioration of
. the insulation may cause current leakage
or electric shock.
@ A location without a flammable or corrosive gas
&'WARNING
' " Never install the unit near a flammable or
\.Y
volatile location. This may cause
explosion or fire.
' " Never install the unit where acid or
\.Y
corrosive gases are present as current
leakage or electric shock may result due to
corrosion.