Mode Settings - Sanyo CHDXR09663* Service Manual

6. Mode Settings

Setting mode 1
<Operating procedure>
Press and hold the
(VENTILATION) button simultaneously for 4
seconds or longer.
Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown in the table of "List of
Item Codes" on the next page.
Press the timer time
change the setting data.
To confirm the changed setting data, press the
button.
(At this time, all displays stop blinking and remain
lit.)
During this mode, "
The outdoor unit address display section displays
"ALL," the item code and number (DN value in the
3
table), and the setting data (8 digits).
(The setting data is displayed in 8 digits. The
display changes between the first 4 digits (Fig.
and the last 4 digits (Fig.
When the first 4 digits are displayed, the top dot of
the colon is illuminated.)
To exit the setting mode, press the
button.
DN
Snowfall sensor usage
Outdoor unit fan Quiet
mode
Energy saving mode
Energy saving operation
plug
Demand 1 current
Demand 2 current
(CHECK) button and
and
and buttons to
" is displayed, blinking.
).
B
(CHECK)
Parameter
0 = Sensor input not present. Control is performed.
1 = Sensor input present. Control is performed.
2 = Sensor input not present. Control is not performed.
3 = Sensor input present. Control is not performed.
0 = Disabled
2 = Quiet mode 2
4 = Quiet mode 4
0 = None
1 = Discharge temp. control only (Mode 3)
2 = Demand only (Mode 2)
3 = Discharge temp. control + Demand (Mode 1)
0 = Independent
1 = All indoor units linked
0 = 0% 1 = 40 ... 4 = 70 7 = 100 8 = 120
9 = 140 10 = 160 11 = 200 12 = –1 (no limit)
0 = 0% 1 = 40 ... 4 = 70 7 = 100 8 = 120
9 = 140 10 = 160 11 = 200 12 = –1 (no limit)
Outdoor Unit Maintenance Remote Controller
Display of first 4 digits
A
5
1
Display of last 4 digits
B
A )
5
1
and
A B
(Example shows display of 0000 0001.)
Description
1 = Quiet mode 1
3 = Quiet mode 3
3 - 12
W-2WAY ECO-i SYSTEM
3
3
are displayed alternately.
2
2