Table of Contents
Advertisement
MIC-WKTI and MIC-WKT-IR Installation Manual
Signal
Washer Pump Live
Washer Pump Neutral
7. Tighten the weatherproof gland then connect the pump power cable to
the appropriate terminals (Live or Neutral) taking care to observe the
correct polarity as shown below. Bosch strongly recommends that the
washer pump power cable should be protected externally by a suitably
rated fuse.
8. Secure all external pipe work and cabling, fill the washer reservoir then
plug in the MIC400 Power Supply Unit.
9. Press the push to test button (SW1) to test the pump operation, hold
button SW1 down to expel the air from the tubing and prime the pump
for operation.
10. When the pump is primed, close the MIC400 Power Supply Unit.
11. Point the MIC400 at the wash nozzle and set the wash wipe position via
the control room interface or via a laptop using Camset.
Bosch Security Systems
Connection
Ident
HD7 pin 1
L
HD7 pin 2
N
Issue 1
Photo showing installation of the washer pump bracket and nozzle installed
on the MIC 4" PCD foot
EN | 12
Advertisement
Table of Contents
