Beltchanging And Agitator Cleaning; Light Bulb Changing; Agitator Servicing - Kenmore 116.23385C Use & Care Manual

LIGHT BULB CHANGING
i cAuT,o.
_Do not plug in or turn on until the vacuum
cleaner is completely reassembled.
1. Remove PowerMate ® cover as shown in BELT
CHANGING AND AGITATOR CLEANING
section.
2. Remove the light
bulb by pulling
straight out.
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the
bulb could overheat surrounding plastic
_arfs.
Push in
to right
3. To replace the
light bulb, carefull
insert fully into
4. Reinstall PowerMate ® cover as shown in
BELTCHANGING AND AGITATOR CLEANING
section.
NOTE: See PARTS AND FEATURES forBulb
number.
AGITATOR SERViCiNG
WARNING
Electrical Shack Or Personal Injury Hazard
Turn offand unplug vacuum cleaner before
performing maintenance. Failure to do so could
result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
TO CHECK THE BRUSHES
_---_- When brushes are
___ fthebase
support bars,
replace the
agitator assembly.
Base Support Bars
i
TO REPLACE AGITATOR ASSEMBLY
|. Remove PowerMate ® cover, belt and agitator
assembly. See "To Remove Belt" in BELT
CHANGING AND AGITATOR CLEANING.
2. Replace agitator assembly.
3. Reinstall belt and PowerMate® cover. See "To
replace belt" in BELTCHANGING AND
AGITATOR CLEANING.
= 21 =