Recirculating; Atlach Mounting Plate To Wall; Preparation Of Top Cabinet - GE EMO3000 Installation Instructions Manual

Installation Instructions
RECIRCULATING
(Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. Attach Mounting Plale to Wall
C2. Prepare Top Cabinet
C3. Check Microwave Assembly
CA. Adjust Blower
C5. Mount lbe Microwave Oven
C6. Install Charcoal Filter
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
\
Altach the plale to tile wall using toggle bolts.
A1 least oIle wood screw IlltlSt be used to attach
die plate lo a wall slud.
[]Remove tile toggle wings from tile bolls.
[] lnserl die bolls inlo tile inounlJng plate lhrough
lbe holes designated Io go into drywall and
reattach the loggle wings lo _(' omo each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
_._Thickness
lToggle Wings
Mounting i / Toggle
P'ete lllll. 'B°'t II
IIV ,_Wall
II b I
Bolt End
_ Place the mounting plate against the wall and
insert lbe loggle wings imo the holes ill the wall
to mount
lbe
plale.
NOTE: Befbre dghlening Ioggle bolls and wood
screw, make s/lre
lille
labs on
lille
IllOllntiIlg
plale
louch tile bottoln of the cabinet when pushed flush
against lbe wall and that lbe plate is properly
centered under the cabinet.
CAUTION: Be carefill to avoid pinching fingers
between the back of lbe mounting plale and the wall.
[] Tighten all bolls. Pull tile plate away from the wall
to help tighten tile bohs.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need
to drill holes for lbe lop supporl screws and
a hole large enough fi_r the power cord to fit dlrough.
L
• Read the instructions oil the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions oil the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in die cabinet bottom.
19