Surface Units And Drip Pans - GE JP200 Owner's Manual And Installation Instructions

ge.com
To clean the surface units, turn the control to the highest setting for a minute. The coils will bum off any soil.
Lift the surface unit about I inch
above the drip pan and pull it out.
Surface Units and Drip Pans
CAUTION
• Be sure all the controls are turned to
OFF
and the
StIFf;Ice tlni[s aI'e C()O1
betore attempting to remove them.
• Do not imme_e the stm'hce units in
liquids of any kind,
• Do not clean the sm_i_ce units in a
dishwasher:
• Do not bend the sm_hce unit I)lug
temfinals.
• Do not attempt to clean, a(!iust or in
any way repair the l)lug-in receptacle.
Toremove a surface unit:
To remove
the drip pans lot cleaning,
the surtilce units nlust be removed first.
Lift the StlI_;Ice unit about 1 inch above
the drip pan and pull it out.
Do not lift the surti_ce unit more than ]
inch. If you do, it may not lie fiat on the
drip pan when you I)lug it back in.
Rel)eated lifting of the sm_i_ce unit more
than 1 inch above the drip pan can
pemmnently damage the receptacle.
Toreplace a surface unit:
• ]),el)lace the drip l)an into the recess in
the cooktop. Make sure opening in the
pan lines up with the receptacle.
• Insert the temfinals ot the surlhce unit
through the opening in the drip pan
and into the receptacle.
• Guide the sm_hce unit into place so it
rests evenly.
Drip Pans
Remove the sm_hce units. Then lift out
the drip pans.
For best results, clean the drip pans bv
hand. Place them in a covered container
(or a plastic bag) with 1/4 cup ammonia
to loosen the soil. Then scrub with a soap
flled scouring pad if necessary. Pdnse
with clean water and polish with a clean
soft cloth.
Thedrip pans may also be cleaned in the
dtshwashe_
Clean the area under
the (lri l) pans often.
Built-up soil, esl)eciallv ,grease ma_ catch
on
fire.
Do not coxer drip pans with foil. Using
foil so close to the receptacle could cause
shock, fire or damaoe, _ to the cooktop.