GE JP200 Owner's Manual And Installation Instructions page 6

Usingthe cooktop.
Throughout this manual, features and appearance may vary from your model.
Cooktop Controls
Yoursurfaceunits and controls are designed to
give you an inhbite choice of heat settlbgs for
surface unit cooklbg,
At both OFF "and HI tile control
clicks
into position.
XA]/en cooking in a quiet kitchen, you
may hear slight clicking sounds--an
indication that tile heat settings you
selected are being maintained.
Switching heats to higher settings
always results in a quicker change than
switching to lower settings.
I II
How to Set the Controls
[] (;rasp tile control knob and push
down.
[] Turn tile knob to tile desired heat
setfin ,
Tile control must be pushed in to set
only fl'om tile OFFposition. \Allen tile
control is in any position other than
OFF,
it may be rotated without pushing in.
Be st/i'e _ot/ttii'n tile control knob
to OFFwhen you finish cooking.
An indicator light will glow when a
suil'ilce unit is on.
Medium Medium
high low
(On some models)
Medklm t Medklm
high low
Medklm
(On some models)
Heat Setting Guide
HI Quick start for cooking; bring water to boil.
Medium High, (Setting halfway between HI and IVIED)
7-9 l\/]aint_lins a tilst boil Oil large _lillO/ints ofti)od.
MED, 4-6
Satlt(_ and brown; keeps ti)od at medium boil or simmei:
Medium Low, (Sett/bg halfway between IVIED and LO)
I-3 Cook alter starting at HI; cooks with little water in a covered pan.
LO Steam rice, cereal; maintains serving temperature (fftoods. Slow
cooking and simmering. At LO settings, melt chocolate and butter
on a small suil'i_ce unit.
NOTE: A t HIor MediumHigh(7-9)neverleavefoodunattended Boilovers cause smoking, greasy
spi//overs maycatchfire.