Replacing The Processor; Removing The Processor - Dell Inspiron 518 Service Manual

Back to Contents Page
Replacing the Processor
Dell™ Inspiron™ 518/519 Service Manual
Removing the Processor
Installing the Processor
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could
damage your system board. For technical service, see the Quick Reference Guide.
Removing the Processor
1. Follow the procedures in Before You
2. Remove the computer cover (see
CAUTION: Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient time
to cool before you touch it.
3. Disconnect the power cables from the ATX_POWER and ATX_CPU connectors (see
4. Remove the processor fan and heat sink assembly from the computer (see
NOTE: Unless a new heat sink is required for the new processor, reuse the original heat sink assembly when you replace the processor.
5. Press and push the release lever down and out to release it from the tab that secures it.
6. Open the processor cover, if applicable.
Dell™ Inspiron™ 518
1 processor cover 2 processor
3 socket 4 release lever
Dell Inspiron 519
Begin.
Removing the Computer Cover).
System Board Components) on the system board.
Replacing the Processor Fan and Heat Sink Assembly).