Function Overview; Rear Terminals; Front Panel Indicator; Hdmi Setup - Magnavox DP170MW8B Owner's Manual

Function Overview

Rear Terminals

1
L
R
AUDIO
OUT
1: AUDIO OUT jacks
Connect an RCA audio cable from here to the audio input jack of
your television or audio device.
2: COMPONENT VIDEO OUT jacks
Connect a component video cable from here to the component
video input jacks of your television.
3: S-VIDEO OUT jack
Connect an S-video cable from here to the S-video input jack of
your television.
4: HDMI OUT jack
Connect an HDMI cable from here to the HDMI compatible port
of a television or other display device.

Front Panel Indicator

1 POWER indicator
Lights up when power is on.
2 PLAY indicator
Lights up when inserted disc is being played back.
Blinks when an unplayable disc is inserted.
3 HDMI indicator
Lights up when there is video signal output from the HDMI OUT jack.

HDMI Setup

Video Output Signal
480 Progressive
720 Progressive
1080 Interlaced
1080 Progressive
* To complete these settings, refer to pages 18-19.
2
Y C /P COMPONENT VIDEO OUT
R R
COAXIAL
VIDEO DIGITAL
C /P HDMI OUT
B B
OUT AUDIO OUT
6 5 4
SETUP > QUICK>
Setting
HDMI MODE
480p
720p
1080i
1080p
3
S-VIDEO
OUT
5: DIGITAL AUDIO OUT COAXIAL jack
Connect a digital audio coaxial cable from here to the digital
audio input jack of your digital audio receiver.
6: VIDEO OUT jack
Connect an RCA video cable from here to the video input jack of
your television.
Note:
• Please purchase the necessary cables at your local store.
(Refer to pages 6-8.)
POWER PLAY HDMI
1 2 3
Note:
• Video and audio signals may distorted temporarily when
changing to/from the HDMI output mode.
• Use a display with an HDMI-compatible port.
• You can check the HDMI connection status by pressing
[DISPLAY] during playback with the HDMI output mode (refer
to page 14).
• The HDMI mode that is not supported by display device is
grayed in the settings.
• If the TV is not compatible with newly selected HDMI output
mode, press and hold [PLAY B] on the front of the unit for
more than 5 seconds to reset the setting to default.
– 9 –
EN