Removing The Display Latch - Dell Latitude C510 Service Manual

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
2. Reconnect the bottom flex cable connector to the inverter connector.
3. Replace the tape that secures the display panel connector and the tape that secures the middle of the
display-feed flex cable to the display panel.
4. Place the bottom edge of the display panel in the bottom of the top cover and elevate the top of the panel
with your hand.
5. Lay the display panel in the top cover.
6. Reinstall the five M2 x 4-mm screws that secure the display panel to the top cover.
Display Latch
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any
installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted
metal surface on the computer.

Removing the Display Latch

1. Remove the hard
2. Remove the display
3. Remove the display
4. Remove the two M2.5 x 5-mm screws and the two M1.7 x 3.5-mm screws that secure the display latch and
bracket to the top cover.
5. Lift the display latch and bracket up and out of the top cover.
Display Latch Removal (14.1-Inch XGA Panel Shown)
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...610/C510%20C610%20Service%20Manual/display.htm (7 of 11)6/21/2004 1:25:35 AM
drive.
assembly.
bezel.