Operations; Basic Operations; System Setup; Audio Setup - Clarion CZ202E Owner's Manual

5. OPERATIONS

Basic Operations

Note:
• Refer to the diagrams in "3. CONTROLS"
when reading this chapter.
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume
raised to the maximum level may harm
your hearing.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [SRC / ] button on the front
panel to turn on the power under standby
mode. The unit goes back to the last
status after power on.
3. Press and hold the [SRC / ] button on
the front panel to turn off the power.
CT (Clock Time) display
• The displayed clock data is based on the
CT (clock time) data in the RDS signal.
5 CZ202E/CZ202ER/CZ202EG
Volume adjustment
Turn the [VOLUME] knob on the front panel.
The adjustable range of volume is 0 to 40.
CAUTION
While driving, keep the volume level at
which external sounds can still be heard.
Playing source selection
Press [SRC / ] button on the front panel
repeatedly to choose desired playing source.
Note:
• Playing source selection means selecting
which mode, such as DISC mode, RADIO
mode and AUX mode.
Display system time
Press the [DISP] button on the front panel to
switch the display information between RDS
information, system time and playing source.
RESET
If you have below problems, pls press
[RESET] button.
• Unit can not power on
• Nothing happens when buttons are
pressed
• Display is not accurate
Note:
* When the [RESET] button is pressed,
preset radio stations, audio setting, etc.
stored in memory are kept.
RESET

System Setup

In any mode, press and hold [DISP] button to
enter system setup. Press [ , ] buttons
to select options, rotate the [VOLUME] knob to
adjust.
AF: ON/OFF
Rotate the [VOLUME] knob to choose AF ON or
OFF.
REG: ON/OFF
Rotate the [VOLUME] knob to choose REG ON
or OFF.
DX/LO (RADIO mode)
Rotate the [VOLUME] knob to choose radio
local or distant at RADIO mode.
• LO: Only stations with strong signal can be
received.
• DX: Stations with strong and weak signals
can be received.
AUX SENS (AUX mode)
Rotate the [VOLUME] knob to choose AUX
Input sensitivity LOW, MID or HIGH at AUX
mode.
SCRN SVR: ON/OFF
Rotate the [VOLUME] knob to choose SCRN
SVR (screen saver) ON or OFF.
SCROLL: ON/OFF
For track information that is longer than the
display panel:
When SCROLL is ON, the LCD will display
ID3 TAG information cyclely, e.g: TRACK-
>FOLDER->FILE->ALBUM->TITLE->ARTIST-
>TRACK->...
When SCOLL is OFF, the LCD will scroll the
ID3 TAG information across the display, the
default is TRACK, but user can adjust it to other
ID3 TAG information by press [DISP] button.

Audio Setup

] button to enter sound effect
Press the [
setting mode. First press shows current EQ.
Rotate the [VOLUME] knob to change the BEAT
EQ in this order:
OFF -> B-BOOST -> IMPACT -> EXCITE ->
CUSTOM
S-CTRL (IPOD mode) : ON/OFF
Rotate the [VOLUME] knob to choose S-CTRL
(Simple Control) ON or OFF.
* Refer to P9.
REAR/S-W
Rotate the [VOLUME] knob to choose REAR
or S-WOOFER (SUB-WOOFER).
TEL-SW
Rotate the [VOLUME] knob to choose
MUTE, ON or OFF.
•
MUTE:
The sound from this unit is muted during
telephone calls.
•
OFF:
This unit continues normal operation even
when the cellular phone is used.
•
ON:
You can listen to your telephone calls from
the speakers connected to this unit.
*When listening to your calls on your car
speakers, you can adjust the volume by
turning the [VOLUME] knob.
BEEP: ON/OFF
Rotate the [VOLUME] knob to choose button
beep sound ON or OFF.
RESET:
1. Select "RESET".
2. Press and hold the [VOLUME] knob to
reset.
3. Settings will be set to the default value.
4. The unit will be turned off automatically.
Note:
• When the [RESET] is selected and you
press and hold the [VOLUME] knob,
radio station frequencies, titles, and
other data stored in memory are cleared.
Rotate the [VOLUME] knob to change the
CUSTOM setting, and press the [VOLUME]
knob,
] button to select
the press [ ] or [
it including: BAS-G -> BAS-F -> BAS-Q