Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Avital Avistart 3001
Summary of Contents for Avital Avistart 3001
- Page 1 AviStart 3001 Installation Manual, Revision B 100199...
-
Page 2: Table Of Contents
Programming Table for System Features ....1 9 Programming Table for Remote Controls ....1 9 AviStart 3001 Installation Manual, Revision B 100199... -
Page 3: Important Information
6 . Turn off dome light or remove dome light fuse to prevent battery drain. This device complies with Part 15 of the FCC rules. Any changes or modifications made to the system without the express approval of Avital Technologies, Inc. could void the user’s authority to operate this equipment. -
Page 4: Main Wiring Diagram
Main Wiring Diagram AviStart 3001 Installation Manual, Revision B 100199... -
Page 5: Pin Connector
Parking Light Polarity Input, (+) or (-) Select Battery (+) 6 Pin Connector Pin Number Wire Color Description Pink Ignition Output #1 Battery +12 Volts Pink Ignition Output #2 Violet Starter Output Gray Heater/AC Output Not Used AviStart 3001 Installation Manual, Revision B 100199... -
Page 6: Installation Procedures
4. Sleeve these wires with vinyl tubing or electrical tape and route them through an existing rubber grommet into the engine compartment. 5 . If an existing grommet is not available, drill a hole and install a snap grommet. AviStart 3001 Installation Manual, Revision B 100199... -
Page 7: Valet Switch
NOTE: Do not connect the RED/WHITE wire to the control unit RED wire. 2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire to control unit BLACK wire. 3. Connect the RED/BLACK wire to the vehicle parking light wire. AviStart 3001 Installation Manual, Revision B 100199... -
Page 8: Reverse Light
3 . Connect the GRAY/WHITE wire to the factory alarm disarm wire. Factory Alarm Rearm There are two types of factory alarm systems that the AviStart can rearm. Con tin ued on next page. AviStart 3001 Installation Manual, Revision B 100199... -
Page 9: Ignition Switch Connections
If only one 14 ga PINK wire is needed, tape the end of the second 14 ga PINK wire to prevent a short circuit. the end of the second 14 ga PINK wire to prevent a short circuit. AviStart 3001 Installation Manual, Revision B 100199... -
Page 10: Glow Plug Light Input
The module can be programmed to turn the ignition "ON" for 15 seconds before the starter engages. This will allow the glow plugs time to warm up and the glow plug light to turn off. AviStart 3001 Installation Manual, Revision B 100199... -
Page 11: Remote Engine Start Neutral Safety Switch Bulletin
Currently, the only vehicles with the combined neutral safety switch that Avital is aware of are General Motors trucks, GM sport utility vehicles, GM column shift passenger cars and Dodge Dakota pickup trucks. There may be additional vehicles with the combined neutral safety switch that require the additional relay. - Page 12 The wire color codes are subject to change. Check all wires with a volt/ohmmeter. If you have any questions, please contact the Technical Support Department. AviStart 3001 Installation Manual, Revision B 100199...
- Page 13 Gen eral Mo tors Sport Util ity Ve hi cles, Trucks and Col umn Shift Pas sen ger Ve hi cles Dodge Da kota Pickup Trucks AviStart 3001 Installation Manual, Revision B 100199...
-
Page 14: Door Lock/Unlock
Some types of door lock sys tems re quire op tional re lays, for ex am ple, re verse po lar ity type door locks. Refer to the diagrams on pages 12 - 14. Posi tive Trig ger Door Locks AviStart 3001 Installation Manual, Revision B 100199... - Page 15 AviStart 3001 Installation Manual, Revision B 100199...
- Page 16 AviStart 3001 Installation Manual, Revision B 100199...
-
Page 17: Tach Wire (Rpm Monitoring)
On most vehicles, the tach wire is easily accessible. If the tach wire is not accessible, there are several alternative choices. Contact Avital Technical Support Department for alternate choices. The following procedure for testing the vehicle tach wire is not exact and may vary with different vehicle make, model and year. -
Page 18: Power And Ground Connections
Features” on page 18. 5 . Press and hold the remote START button. 6. The parking lights will flash two times to confirm the RPMs have been memorized. 7 . Release the START button. AviStart 3001 Installation Manual, Revision B 100199... -
Page 19: Programmable Features
6 . Follow the “Secondary Action.” You will hear a number of beeps to confirm that you have changed the setting of that feature. 7 . Turn the ignition key “OFF.” 8 . Repeat steps 1-7 for any other feature you wish to program. AviStart 3001 Installation Manual, Revision B 100199... -
Page 20: Programming Table For System Features
Instant Remote Control — will beep twice. All codes are Code Deletion erased out of memory. © 1999 Avital Technologies, Inc., A Division of Clifford Electronics Part Num ber: 32- 3001B/AviStart 3001IM/ 1099 AviStart 3001 Installation Manual, Revision B 100199...