Avital AviStart 3200 Installation Manual page 30

Channels Four, Five and Six: Channels Four through Six are used to assign the arm, disarm and panic functions
to separate buttons on the remote control. Teaching a button to Channel Four erases all information about that
remote from memory. Any auxiliary functions that are desired will have to be reprogrammed. Similarly, if the
remote is set up to use the separate arm, disarm and panic channels and a button from that remote is entered
into Channel One, the remote will be erased from memory, and the system will only recognize the button that
was entered into Channel One.
3.
4.
You can advance from programming one channel to another by releasing the Valet/Program switch and tapping
it to advance channels and then HOLDING it. For instance: You have programmed Channel 1 and you want to
program Channel 2. Release the Valet/Program switch. Press it one time and release it to advance from Channel
1 to Channel 2. Now, press and HOLD the Valet/Program switch. The LED will flash two times and the horn will
honk twice (if connected). As before, do not release it.
If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice
and release it to advance to Channel 3. Then press it once more and HOLD it. The horn will honk three times (if
connected) and the LED will flash three times to confirm it is ready to receive the code from the transmitter.
Learn Routine will be exited if:
I Ignition is turned off.
I Program switch is pressed too many times.
I More than 15 seconds elapses between programming steps.
One long horn honk indicates that Learn Routine has been exited.
30
Transmit. While HOLDING the Valet/Program switch, press the button on the transmitter
that you would like to control the selected receiver channel. The unit will chirp to confirm
that the code has been successfully programmed. It is not possible to teach a transmitter
button to the system more than once.
Release. Once the code is learned, the Valet/Program switch can be released.
© 2000 Directed Electronics, Inc. Vista, CA