GMC 2012 Canyon Owner's Manual page 333

5. Check that the jumper cables do
not have loose or missing
insulation. If they do, you could
get a shock. The vehicles could
be damaged too.
Before you connect the cables,
here are some basic things you
should know. Positive (+) will go
to positive (+) or to a remote
positive (+) terminal if the vehicle
has one. Negative ( ) will go to a
heavy, unpainted metal engine
part or to a remote negative ( )
terminal if the vehicle has one.
Do not connect positive (+) to
negative ( ) or you will get a
short that would damage the
battery and maybe other parts
too. And do not connect the
negative ( ) cable to the
negative ( ) terminal on the
dead battery because this can
cause sparks.
6. Connect the red positive (+)
cable to the positive (+) terminal
of the dead battery. Use a
remote positive (+) terminal if
the vehicle has one.
7. Do not let the other end touch
metal. Connect it to the
positive (+) terminal of the
good battery. Use a remote
positive (+) terminal if the
vehicle has one.
8. Now connect the black
negative ( ) cable to the
negative ( ) terminal of the
good battery. Use a remote
negative ( ) terminal if the
vehicle has one.
Do not let the other end touch
anything until the next step. The
other end of the negative ( )
cable does not go to the dead
battery. It goes to a heavy,
unpainted metal engine part,
or to a remote negative ( )
terminal on the vehicle with the
dead battery.
9. Connect the other end of the
negative ( ) cable at least 45 cm
(18 inches) away from the dead
battery, but not near engine
parts that move. The electrical
connection is just as good there,
and the chance of sparks getting
back to the battery is much less.
Your vehicle has a remote
negative ( ) terminal for this
purpose.