Air Conditionercontrols - GE AGM14 Owner's Manual & Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool on
Fanon
Energy
Saveroi
Air ConditionerControls
Remote Control
Controls
O ON/OFF Pad
Turns air conditioner on and off.
oisplav
Shows the set temi)eramre or time remaining
on tilller.
O MODE
Use to set tile air conditioner to COOLor
FAN m ode.
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
O FAN Pad
Use to set the _im speed to LOW(F1), MED (F2)
or HIGH (F3).
O ENERGYSAVER
(on some models)
Controls tile tim.
0]_-The tim and c()mi)ressor c)'cle on and
off. This results in wider \_riafions of room
temperature and humidiP,'. Nommllv used
when tile room is tmoccuI)ied. NOTE:
Thefan
will continue to run for a short time after the
compressorcyclesoff
OFF
Tile tim rtms all tile time, while tile
COIIII)I'eSSOI"
cycles
on [In(1 o]C{ ',
This t_'atm'e must be set at
OFF
in order to use
the tim settings (on the mode control).
NOTE: Onsome models, the ENERGY SAVER feature
cannot be set on the air cond/tione_It must be set uslhg
the remote control
O CIRCULAIRE(on some models)
FOF (onfint/otls side-to-side air circulation
(cool settings only), set the Circulaire switch
to ON.
Dn" fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFK
O TIMER Pad
0/_-_ hen tile air conditioner is off, it can be
set to automatically come on in 1 to ] 2 ho/u_
or 1 to 24 hom_ (depending on model) at its
previous setting. Each touch
of tile TIMER pad
or tile INCREASE•/DECREASE• pads
(del)ending on model) will set tile diner
in hom_.
OlaF _&l/en the air conditioner is on, it can be
set to automatically mm off in 1 to 12 hom_ or
1 to 24 hems (depending on model). Each
touch of tile TIMER pad or tile INCREASE• /
DECREASE• pads (depending
on model) will
set tile timer in hom_.
To cancel the tinier, press tile TIMER pad until
tile display time disappears.
Remote Control Signal Receiver
4
Remote Control
To ensure proper operation, aim tile remote
control at tile signal receiver on tile air
conditioner.
Tile remote control signal has a range of
up to 21 feet.
Make sm'e nothing is between tile air conditioner
and the remote control that could block the
signal.
Make sm'e batteries are fl'esh and installed
correctly as indicated on tile remote control.