I Timer Operation G Off Timer Operation; G On Timer Operation - Daikin Inverter FTKD50BSG Operational Manual

Timer Operation
Timer functions are useful for automatically
switching the air conditioner on or off at night or in
the morning. You can also use OFF TIMER and
ON TIMER in combination.
OFF TIMER operation
G Check that the clock is correct.
If not, set the clock to the present time. (See page 9.)
1 OFF TIMER
Press while the air conditioner
is operating.
2
Press until the time setting
reaches the point you like.
G Every pressing of either button increases or
decreases the time setting by ten minutes.
Holding down either button changes the
setting rapidly.
OFF TIMER
3
Press once again.
I I I I I To cancel the timer:
CANCEL
Press .
Then the TIMER lamp goes off.
Notes on OFF TIMER
G NIGHT SET MODE
When the OFF TIMER is set, the air conditioner
automatically adjusts the temperature setting
(0.5°C up in COOL) to prevent excessive
cooling for your pleasant sleep.
is displayed.
blinks.
Then the TIMER lamp
lights up.
ON TIMER operation
G Check that the clock is correct. If not, set the
clock to the present time. (See page 9.)
ON TIMER
1
Press while the air conditioner is
not operating.
2
Press until the time setting
reaches the point you like.
G Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3
ON TIMER
Press once again.
Then the TIMER lamp
lights up.
Combining ON TIMER and OFF TIMER
G A sample setting for combining the two timers is shown below.
(Example)
Present time: 11:00 PM
(The unit operating)
    
OFF TIMER at 0:00 a.m.
Combined
    
ON TIMER at 7:00 a.m.
Notes on ON,OFF TIMER
G When TIMER is set, the present time is not displayed.
G Once you set ON,OFF TIMER, the time setting is kept in
the memory. (The memory is canceled when remote
controller batteries are replaced.)
G When operating the unit via the ON/OFF Timer, the actual
length of operation may vary from the time entered by the
user.(Maximum approx. 10 minutes.)
ATTENTION
I In the following cases, set the timer again.
G After a breaker has turned OFF.
G After a power failure.
G After replacing batteries in the remote controller.
is displayed.
blinks.
15