Wash Cycle Information - Bosch SGV45E03UC Use & Care Manual

Clean the Exterior Door Panel
Colored Doors
Use only a soft cloth that is lightly dampened with soapy water.
Stainless Steel Doors
Use a soft cloth with a non-abrasive cleaner (preferably a liquid spray) made for cleaning stainless steel. For the best results,
apply the stainless steel cleaner to the cloth, then wipe the surface.
Clean the Door Gasket and Door Seal
Regularly clean the door gasket with a damp cloth to remove food particles and other debris. Also clean the door seal, located
inside the dishwasher at the bottom of the door.
Wash Cycle Information
To save energy, this dishwasher has a "Smart Control" that automatically adjust the cycle based on soil loads and incoming
water temperature. The "Smart Control" makes decisions that can cause the cycle time and water usage to adjust intermittently.
The cycle times listed in the Use and Care manual are based on normal soil loads and 120°F incoming water and will vary based
on your actual conditions.
The Half Load feature will reduce the water consumption by approximately 30 percent in the Power Scrub Plus, Regular, and
Auto Wash cycles.
If additional drying heat is selected, the cycle will be extended by approximately 20 minutes.
If the unit is out of rinse agent, the OPTIDRY
TM
feature will automatically extend the cycle time by approximately 10 minutes.
If Pre Soak is selected, the cycle will be extended by approximately 15 minutes.
SANITIZED
A dishwasher cycle that has the Sanitized symbol has been tested to meet very strict requirements of wash time and water
temperature to ensure dishware and kitchenware sanitization. All cycles that meet the Sanitized requirements heat the water to
a minimum of 156°F.
NOTE: If your household water supply is too hot, your dishwasher's heating time may be reduced and the "Sanitized" light or
symbol may not illuminate. Your Dishwasher Installation Manual has information on the recommended temperature for your
household hot water supply.
16