Bosch SGV45E03UC Getting Started Manual

GETTING STARTED
WITH YOUR NEW DISHWASHER
STEP 1- ADDING RINSE AGENT
For Proper Drying Always use Rinse Agent
Rinse Agent
Level
•
Lift tab to
open
•
To add Rinse Agent
pour on the arrow
•
Turn arrow to
adjust the amount
of rinse agent
dispensed
STEP 2 - ADDING DETERGENT
3 TBS MAX
2 TBS (25 ML)
1 TBS (15 ML)
•
Add
Detergent
•
To close
2
•
If you should
need to open
the cover
STEP 3 - TO START THE DISHWASHER
1) Close the door
Exposed
Front
Controls
2) Turn on
1) Open the door
Hidden Top
Controls
2) Turn on
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND
even if your detergent containes Rinse Agent
•
Add Rinse Agent when the light
on the control panel illuminates
or (Model Dependent)
Rinse Agent Level indicator on
the dispenser changes to a
light silver color
Arrow
Turn
Decrease Increase
for for
Streaks on Spots on
glasses glasses
•
Use fresh powdered detergent
for best results
•
1 tablespoon will clean most loads
•
3 tablespoons Max, do not overfill
•
When using detergent tabs, lay
them flat to avoid contact with the
cover
Slide cover fully left
Push rear of cover down
2
firmly until you hear the
CLICK
•
Push the blue button in
(NOT DOWN)
4) The unit will
then start
3) Select a cycle
4) Close the
door to start
3) Select a cycle
IMPORTANT SAFETY NOTICES.
FREQUENTLY ASKED
QUESTIONS
Run Time
To save energy, this dishwasher has a "Smart Control" that
automatically adjusts the cycle based on soil loads and incom-
ing water temperature. The "Smart Control" makes decisions
that can cause the cycle time and water usage to adjust at
discrete times, and suddenly change in midcycle. The cycle
times listed in the Use and Care manual are based on normal soil
loads and 120°F incoming water and will vary based on your
actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
• Countdown Display at "0"
• Clean Light illuminates
• Cycle completion signal sounds (tone adjustable)
• Cycle indicator light that shines on floor goes out

Canceling a Cycle

To cancel a cycle in process, press and hold the two buttons
labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher
as normal
Cancel Drain
To Contact Customer Service
With the dishwasher door open, locate the label on the middle
of the door. There you will find the:
• Model Number
• Serial Number (FD#########)
9000162018 (8602)