Ir Remote Commander (Supplied) - Sony PMW-50 Operating Instructions Manual

IR Remote Commander (Supplied)

Before use, pull out the insulation sheet from the
battery holder.
1
SHOTMARK
2
THUMBNAIL SUB CLIP
PREV PLAY/PAUSE
.
FREV
m
REC
z
1.
SHOTMARK 1 and 2 buttons (page 21)
2.
THUMBNAIL button
3.
PREV (previous clip jump) button
4.
F REV (fast reverse) button
5.
PLAY/PAUSE button
6.
REC (record) buttons
Press the z button together with the unmarked
button (safety button) to start recording.
7.
REC PAUSE buttons
Press the X button together with the unmarked
button (safety button) to pause recording.
8.
PUSH SET button (four-way arrow key)
It functions the same as the SEL/SET button on
the recorder.
9.
NEXT button
10.
STOP button
11.
F FWD (fast forward) button
Notes
• The ZOOM T/W, SUB CLIP, and PUSH AF buttons
have no function.
• To avoid malfunctions, the remote control function is
automatically deactivated when the recorder is turned
off. Activate the function each time when required
after you turn the recorder on.
8 Part Identification
Insulation sheet
PUSH SET
T
ZOOM
W
NEXT STOP
u > x
FFWD
M
REC PAUSE PUSH AF
X
Replacing the battery in the IR Remote
Commander
Use a commercially available CR2025 lithium
battery. Do not use any battery other than a
CR2025.
1
Hold down the lock lever 1, pull out
the battery holder 2, and remove the
battery.
1
2
Place a new battery in the battery
holder with the + symbol facing
upward, then push the battery holder
into the IR Remote Commander until it
clicks.
WARNING
• Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
• Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.
2