Chapter 3 Preparations; Preparing Power Sources; Supplying Power; Attaching A Battery Pack - Sony PMW-1000 Operation Manual

Preparations

Preparing Power Sources

This unit can be powered by AC power, DC power, or a
battery pack.
For safety, use only the Sony battery packs listed below.
Lithium-ion battery pack: BP-L80S
Note
If you load or remove a battery pack incorrectly, it may fall
and cause bodily injury. Follow the procedures described
below to load or remove them.

Supplying power

AC power supply
Connect the AC IN connector to an AC power source using
the specified AC power cord. To supply AC power to the
unit, press the on/standby button (1) on the front panel
and hold it down for a short time (0.25 seconds or longer).
and the POWER switch on the rear panel to = (on).
DC power supply
Connect the DC IN 12V connector to a DC power source.
To supply DC power to the unit, press the on/standby
button (1) on the front panel and hold it down for a short
time (0.25 seconds or longer), and turn off the POWER
switch on the rear panel. If the POWER switch on the rear
panel is set to = (on), AC power is supplied.
Battery power supply
You can use the BP-L80S Battery Pack with this unit.
To use battery pack, a BKP-L551 Battery Adaptor and a
BC-L100 Battery Charger are also required.
Continuous recording time at room temperature
BP-L80S lithium-ion battery pack: Approx. 80 minutes
20
Preparing Power Sources
Chapter
For details on charging battery packs, refer to the
operation manual for the battery charger.
Notes about battery usage
• As long as a battery is connected to the unit, electric
current flows in the unit to keep the CPU in the standby
state even when the unit is not powered.
• Before using the batteries, be sure to charge them fully
with the special battery charger. Refer to the operating
instructions for your battery charger for more
information about how to charge the batteries.
• Batteries may not be completely charged if you charge
them immediately after use when they are still warm.
You should wait until the batteries cool before charging
them.

Attaching a battery pack

Use the BKP-L551 in the following way to attach and
remove the BP-L80S Battery Pack.
For details on attaching the BKP-L551, refer to the
installation manual for the BKP-L551.
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law in
the relative area or country.
3