Versatile Interfaces
Analog Interfaces
Incorporating comprehensive analog interfaces for both video
and audio, the DSR-2000A interfaces with current analog
equipment to ensure smooth upgrading to future digital
systems. Composite, component, S-Video (Y/C) for video,
and XLR audio interfaces are provided.
Digital Interfaces
The DSR-2000A also has a full range of standard digital
interfaces such as SDI, SDTI (QSDI), AES/EBU and i.LINK
(DV In/Out) interfaces.
Taking advantage of these digital interfaces, the DSR-2000A
offers full access to a wide variety of digital equipment like
the SDI-based editing system with the Betacam SX™ or
Digital Betacam™ formats or a cut editing system with the
Sony DSR-450WS DVCAM Camcorder or consumer DV
camcorder via i.LINK interface.
●
SDTI (Serial Data Transport Interface) is defined as SMPTE 305M.
●
SDTI (QSDI) is the DV compressed signal interface which is defined as
SMPTE 322M.
●
i.LINK stands for IEEE1394-1995 standards and their revisions.
is the logo for products that implement i.LINK.
Remote Control Interface (RS-422A)
The DSR-2000A is fully equipped with an RS-422A interface
that is the industry standard for professional editing. It allows
the DSR-2000A to interface with Sony VTRs, editing
controllers and non-linear editing systems.
DSR-2000A Rear Panel
Comprehensive,
Convenient Functions
16:9 Aspect Ratio Capability
By receiving a wide aspect ID signal, the DSR-2000A records and plays
back 16:9 aspect ratio pictures shot with the Sony DSR-450WS or
DSR-PDX10 DVCAM Camcorder.
Video Process Control
To provide highly stable video signals,
the DSR-2000A is equipped with
the process control for both analog
and digital outputs. This provides
accurate control of video level,
chroma level, chroma phase (hue),
set up, Y/C delay, Sync phase and SC (Sub Carrier) phase for composite,
component, S-Video and SDI outputs.
VITC
In addition to TC, VITC (Vertical Interval Time Code) is supported by the
DSR-2000A. Since the VITC data is stored in a different portion of the tape
from that of TC, the DSR-2000A handles two kinds of TC data.
Channel Condition Monitoring
The DSR-2000A has a three-color
channel condition indicator, with each
color representing a particular error
rate threshold level. This function
enables you to quickly recognize the
condition of a VTR or tape for more
reliable editing operation.
Built-in Signal Generator
Equipped with a built-in signal generator, the DSR-2000A can generate a
color bar or black burst for video, and 1 kHz tone or mute for audio. This
is very convenient for creating pre-striped tapes prior to editing.