Table of Contents
Advertisement
26
SPECIFICATIONS (NTSC MODELS)
DSR-50
Portable Recorder
General
System
NTSC
DC input
XLR 4-pin (male), +12 V
Power consumption
15 W
Operating temperature
41 °F to 104 °F (5 °C to 40 °C)
Storage temperature
-4 °F to 140 °F (-20 °C to 60 °C)
Tape speed
Approx. 28.2 mm/s (DVCAM mode),
Approx. 18.8 mm/s (DV SP mode)
Recording/Playback time
184 minutes (DVCAM mode), 270 minutes (DV SP mode),
with PDV-184ME cassette
40 minutes (DVCAM mode), 60 minutes (DV SP mode),
with PDVM-40ME cassette
Weight
8 lb 9 oz (3.9 kg), excluding battery and tape
Dimensions (W x H x D)
9 3/4 x 3 3/4 x 12 1/4 inches (247 x 92.5 x 311 mm),
excluding projections
11 x 4 x 12 1/2 inches (279 x 99 x 315 mm),
including projections
Video
Recording mode
DVCAM/DV (SP mode only)
Playback mode
DVCAM/DV (SP mode only)
Audio
Recording mode
48.0 kHz/16-bit (2CH)/
32.0 kHz/12-bit (4CH)/automatic (DV IN)
Playback mode
48.0 kHz/16-bit (2CH)/32.0 kHz/12-bit (4CH)
32.0 kHz/16-bit (2CH)/44.1 kHz/16-bit (2CH)
(automatically selected)
Input/Output Terminals
Video IN Composite
1.0 Vp-p, 75 Ω, Sync negative
S (4-pin mini DIN)
Y: 1.0 Vp-p, 75 Ω, Sync negative
C: 0.286 Vp-p (subcarrier burst) 75 Ω
DSR-DR1000A
General
Power requirements
AC 100 V to 240 V, 50/60 Hz
Power consumption
75 W
Operating temperature
41 °F to 104 °F (5 °C to 40 °C)
Storage temperature
-4 °F to 140 °F (-20 °C to 60 °C)
Operating humidity
Less than 80%
Storage humidity
Less than 90%
Weight
16 lb 10 oz (7.5 kg)
Dimensions (W x H x D)
8 3/8 x 5 1/8 x 16 5/8 inches, without projection
(210 x 130 x 422 mm)
Recording/playback time
12 hours
Video Performance
Bandwidth
Luminance
(via analog component I/O) Chrominance
More than 54 dB
S/N ratio
(via analog component I/O)
K-factor (K2T, KPB)
Less than 2.0%
Y/C delay
Less than 30 ns
Audio Performance
Frequency response
2CH mode (48 kHz/16-bit) 20 Hz to 20 kHz ±1.0 dB
4CH mode (32 kHz/12-bit) 20 Hz to 14.5 kHz ±1.0 dB
Dynamic range
More than 87 dB
Distortion (THD + N)
Less than 0.07% (48 kHz)
Video Signal Inputs
Analog
REF. Video (BNC x 2)
0.286 Vp-p, 75 Ω sync negative
Composite Video (BNC x 2),
1.0 Vp-p, 75 Ω sync negative
loop-through connection
*1
Component (BNC x 3)
*1
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω(75% color bar)
B-Y: 0.7 Vp-p, 75 Ω (75% color bar)
S-Video (BNC x 2)
*2
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.286 Vp-p, 75 Ω (at burst level)
Digital
SDI (BNC x 2)
Conforms to Serial Digital Interface (270 Mb/s), SMPTE259M
i.LINK (DV)(6-pin x 1)
IEEE 1394-based
*1:Composite, Component and S-video inputs share the same BNC connectors.
*2:Composite, Component and S-video outputs share the same BNC connectors.
*3:The volume of monitor can be controlled by the PHONE LEVEL control knob.
Hard Disk Recorder
30 Hz to 5.0 MHz ±1.0
30 Hz to 1.5 MHz +1.0/-5.0 dB
Audio IN
XLR 3-pin (female) (+4 dBu/-20 dBu/-60 dBu) x 4,
impedance more than 3 kΩ with +48 V power supply
(independently switched for each channel)
Camera IN
26-pin camera connector
Composite
1.0 Vp-p, 75 Ω, Sync negative
Component
Y: 1.0 Vp-p, 75 Ω, Sync negative
B-Y: 0.7 Vp-p, 75 Ω, R-Y: 0.7 Vp-p, 75 Ω
Reference IN
BNC, Black Burst 75 Ω, Sync negative (use Video IN)
Video OUT 1 (Monitor)
BNC, 1.0 Vp-p, 75 Ω, Sync negative
Composite
Superimpose On/Off
Video OUT 2 Composite
BNC, 1.0 Vp-p, 75 Ω, Sync negative
S (4-pin mini DIN)
Y: 1.0 Vp-p, 75 Ω, Sync negative
C: 0.286 Vp-p (subcarrier burst) 75 Ω
Component OUT
BNC x 3
Y: 1.0 Vp-p, 75 Ω, Sync negative
B-Y/R-Y: 0.7 Vp-p, 75 Ω
Audio OUT
PIN Jack x 4, -10 dBu
Standard output level -20 dB from full bit
Audio OUT (Monitor)
PIN Jack
DV IN/OUT
6-pin (with lock)
Timecode IN
BNC, 0.5 to 18 Vp-p, 10 kΩ
Timecode OUT
BNC, 2.2 Vp-p, 600 Ω/1.2 Vp-p, 75 Ω
Control S
Stereo mini jack
Remote
Stereo mini jack
(Edge High/Edge Low/Level High/Level Low) (Tally)
Control
Stereo mini-mini jack (compatible with LANC as a player)
Headphone jack (left side) Stereo standard jack, -19 dBu, with Level Control
Other
Color LCD monitor
2.5-inch (viewable area measured diagonally) type, 200,000 dots
Supplied accessories
LCD Protection Cover, Cleaning Cassette
Audio Signal Inputs
Analog
Audio (XLR 3-pin female x 2)
-6/0/+4 dBu (selectable by menu), high impedance
Digital
AES/EBU (BNC x 2)
75 Ω, unbalanced
Video Signal Outputs
Analog
Composite 1/2(SUPER) (BNC x2)
*2
1.0 Vp-p, 75 Ω, sync negative
Component (BNC x 3)
*2
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω (75% color bar)
B-Y: 0.7 Vp-p, 75 Ω (75% color bar)
S-Video (BNC x 2)
*2
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.286 Vp-p, 75 Ω (at burst level)
Digital
SDI (BNC x 2)
Conforms to Serial Digital Interface (270 Mb/s), SMPTE259M
i.LINK (DV) (6-pin x 1)
IEEE 1394-based
Audio Signal Outputs
Audio (Analog)
Audio (XLR 3-pin male x 2)
-6/0/+4 dBu (selectable by menu)
Monitor (RCA x 1)
*3
- ∞ to -11 dBu, 47kΩ, unbalanced (-20 dBFS)
Headphone
- ∞ to -13 dBu, 8Ω, unbalanced (-20 dBFS)
(JM-60 headphone jack x 1)
Audio (Digital)
AES/EBU (BNC x 2)
75 Ω, unbalanced
Time Code
Time Code In (BNC x 1)
0.5 Vp-p to 18.0 Vp-p, 3 kΩ, unbalanced
Time Code Out (BNC x 1)
2.2 Vp-p, 600 Ω, unbalanced
Remote
RS-422A
D-sub 9-pin, female x 2
Control
Mini jack x 1
Network
Ethernet (x 1)
10/100 Base-T Ethernet, RJ-45 modular jack
Supplied Accessories
AC power cord x 1, RM-LG2 (Remote Control Unit) x 1, Operation manual (CD-ROM) x 1,
Warranty card x 1
Advertisement
Table of Contents
