Specifications - Sony F23 Operation Manual

3
Clean the optical contact tips (white), using a cotton
swab moistened with alcohol.
Optical contacts (white)
4
Reinsert the alignment sleeve remover with the
attached alignment sleeve into the connector and push
it in until you hear a click.
5
Rotate the alignment sleeve remover counterclockwise
to fasten the alignment sleeve. Then pull out the
alignment sleeve remover.
28

Specifications

Alignment sleeve
Specifications
General
Power requirements
DC 10.5–17 V
Power consumption
4.5 W max.
Operating temperature
0°C to +40°C (32°F to 104°F)
Storage temperature
−20°C to +60°C (−4°F to +140°F)
Mass Approx. 720 g (1 lb 9 oz)
Dimensions
151 (6)
DC IN 10.5-17V
Input/output connectors
VTR connector LEMO optical/electric composite
connector (1)
DC IN connector XLR type, 4-pin, male (1)
Design and specifications are subject to change without
notice.
Connectors for optical/electric composite cables:
• LEMO PUW.3K.93C.TLCC96 (to the "CAMERA"
®
connector on the VTR)
• LEMO FUW.3K.93C.TLMC96 (to the "VTR"
®
connector on the camera)
Caution on the optical/electric composite cable:
For connection between the VTR and the camera, be sure
to use an optical/electric signal composite cable with the
connectors specified in this manual in order to comply with
the limit for EMC regulations.
Unit: mm (inches)