Preparing The Power Supply; Connection And Operation For Camera Power; Supplying Power To The Adapter - Sony F23 Operation Manual

Preparing the Power
Supply
This adapter operates on 12 V (10.5 to 17 V) DC.
Connection and Operation for
Camera Power
Supplying power via the CA-F101
If the adapter is attached to the rear of the camera, the
power supply to the DC IN connector (XLR 4-pin) of the
adapter is fed to the camera via the adapter.
Connect the power to the adapter as mentioned in
"Connecting a Power to the Adapter" below and set the
CAM POWER switch of the camera to the CA side.
Note
If the adapter is mounted on top, power is not fed to the
camera.
Supplying power directly to the camera
If power is supplied via the DC IN connector (LEMO 8-
pin) of the camera, power is also supplied to the adapter
attached to either the top or the rear of the camera when
you set the CAM POWER switch of the camera to the ON
side.

Supplying Power to the Adapter

To use an AC power source
An AC power source can be connected, using the AC-
DN2B AC Adaptor.
1
Attach the AC-DN2B to the adapter.
2
Connect the DC power cord supplied with the AC-
DN2B to the DC IN connector of the adapter.
3
Connect the AC-DN2B to an AC power source.
To use a battery pack
The BP-GL95 Lithium-ion Battery Pack can be used.
Attach the BKP-L551 Battery Adaptor to the adapter, and
connect the BP-GL95 Lithium-ion Battery Pack to the
adapter.
24

Preparing the Power Supply

Notes
• Remove the battery pack if the adapter will be out of use
for an extended period.
• Charge the battery, using the specified battery charger,
before use.
For charging, refer to the instructions for the battery
charger.
1
Attach the BKP-L551 Battery Adaptor to the CA-
F101.
CA-F101
2
Aligning the groove on the BP-GL95 with the
projection on the BKP-L551, slide the BP-GL95 so
that the connectors engage.
3
Connect the DC cable of the BKP-L551 to the DC IN
connector of the CA-F101.
BKP-L551