Advertisement
5.
Follow the instructions on your screen. At the end
of the procedure, restart your computer to use the
program.
I
nstalling the CD-ROM Drivers
If you are using the Windows 3.x operating system,
you must install special drivers to make your built-in
CD-ROM drive work properly.
If you are using the Windows 95 operating system, you
do not need to install the CD-ROM drivers.
Windows 3. x
To install the CD-ROM drivers in the Windows 3.x oper-
ating system, follow these steps:
1.
Save your work and exit Windows before using
the installation program.
2.
Insert the MS-DOS Utilities diskette into the
diskette drive.
®
3.
At an MS-DOS
prompt, type a: to change to the
diskette drive, if necessary.
4.
Type install.
5.
Follow the instructions on your screen to com-
plete the installation.
6.
Restart the computer to activate the new drivers.
7.
Add the following line to your config.sys file:
lastdrive=k
If you need more information about how to edit your
config.sys file, see your MS-DOS documentation.
I
nstalling the MS-DOS Utilities
The MS-DOS utilities let you configure certain features
of your computer, such as the asset tag code and suspend-
to-disk partition.
4
Installing Utilities and Drivers
Windows 3. x, Windows for
Workgroups 3. x, and Windows 95
The MS-DOS utilities are automatically installed when
you install the Dell Control Center in the Windows 3.x,
Windows for Workgroups 3.x, and Windows 95 operating
systems. The installation program places the mks2d.exe,
rms2d.exe, and asset.com utilities in your c:\dell\util
directory.
For more information on using the asset tag code or
suspend-to-disk partition utilities, see the readme.s2d
file in the same directory.
To use the MS-DOS utilities in the Windows 95 operat-
ing system, Dell recommends that you restart your
computer in MS-DOS mode. To restart in MS-DOS
mode, click the Start button, and then click Shut Down.
Select the Restart in MS-DOS Mode option, and then
click the OK button.
Windows NT 3.51
To install the MS-DOS utilities in the Windows NT 3.51
operating system, follow these steps:
1.
Insert the Dell Control Center diskette into the
diskette drive.
2.
Copy each of the MS-DOS utilities on the Dell
Control Center diskette to your hard-disk drive.
At a command prompt, type copy a:\
filename and press <
mks2d.exe, rms2d.exe, asset.com, or readme.s2d.
3.
Restart your computer to activate the utility.
For more information on using the asset tag code or
suspend-to-disk partition utilities, see the readme.s2d
file.
I
nstalling the PC Card Manager
Utility
If you are using the Windows 3.x operating system, the
PC Card Manager lets you examine a PC Card's configu-
ration and reconfigure an installed PC Card.
If you have the Windows 95 operating system, use the
operating system's PC Card utility to configure PC
Cards. It is not necessary to install a separate utility from
diskette.
>
where filename is
ENTER
,
Advertisement
