Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual page 68

No
13 Unable to map adapter registers.
14 ddi_get_iblock_cookie-ERROR
15 Unable to install interrupt routine.
16 ddi_create_minor_node failed
17 ATTACH failed
18 OPEN failed: ENOMEM
19 CLOSE: stream==NULL
20 bind to 802.2 failed
Duplex are invalid !! Please change
21
the partner's duplex Full.
22 DL_DETACH_REQ: No board ptr
23 fjgi_param_register error
24 fjgi_board_alloc_mem failed !!
25 Error filling TX ring
26 status block can't alloced!
27 status block can't alloced handle!
28 status block can't bind handle!
fjgi_board_init_mem: Failed to
29
dma_alloc !!
30 statistic block can't alloced!
31 hwmib block can't alloced handle!
32 hwmib block can't bind handle!
fjgi_board_init_mem: Failed to dma
33
alloc2!!
34 Illegal value for LinkSpeed_A
35 fjgi_hw_init:Step 22 failed
36 fjgi_hw_init:Step 23 failed
37 fjgi_hw_init:Step 43 failed
Illegal combination of values AutoNeg
38
and Speed
Message Cause
Mapping of the adapter
registers failed.
The driver could not allocate
interrupt resources.
Creation of a device file
failed.
The driver was not loaded to
the kernel successfully.
The driver could not allocate
resources.
A different protocol is being
used.
With
PW008GE4/PW0G8GE1/SE0X7GD2X
, the other end is using half
duplex mode.
The adapter was not
recognized.
The driver could not allocate
resources for the ndd
parameter.
The driver could not allocate
resources.
The driver could not allocate
transmit resources.
The driver could not allocate
status information
resources.
The driver could not allocate
DMA resources.
The driver could not allocate
statistic information
resources.
The driver could not allocate
DMA resources.
The value of LinkSpeed_A in
the configuration file is
incorrect.
An error occurred during
initialization of the
adapter.
Auto speed can not be used in
fixed mode.
A.1 Console Messages
Workaround
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
With
PW008GE4/PW0G8GE1/SE0X7
GD2X, only full duplex is
available. Change the
duplex mode of the other
end to Full.
Check the mounting
status of the adapter.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Set the correct value for
LinkSpeed_A.
A hardware failure
occurred. Please contact
your service provider.
Set a value other than
Auto for LinkSpeed_A.
61