Fujitsu LifeBook P2110 Bios Manual page 5

Primary Master Submenu of the Main Menu
The Primary Master submenu identifies which ATA
devices are installed.
Main
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1 Help
ESC Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options
Type: • Auto
• None
• CD-ROM
• Hard Disk
Cylinders: • A number
between 0
and 65,535
Heads: • A number
between 1
and 16
PhoenixBIOS Setup Utility
Advanced Security
Primary Master [TOSHIBA MK3017GAP-(PM)]
[Auto]
30006MB
[16 Sectors]
[Enabled]
[FAST PIO 4]
[Ultra DMA 4]
Select Item -/Space
Select Menu Enter
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may also be displayed.
Power Boot Info
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
Select Sub-Menu
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected,
all of the following Set-up items do not appear. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive. Select CD-ROM to select parameters for
CD-ROM drive.
This item appears only when the type is identified as Hard Disk.
When Hard Disk is selected, you can change the value. This field
is changed by incrementing (pressing the [Spacebar]) or by typing
in the number.
This item appears only when the type is identified as Hard Disk.
When Hard Disk is selected, you can change the value. This field
is changed by incrementing (pressing the [Spacebar]) or by typing
in the number.
M a i n M e n u
Exit
Item Specific Help
F9 Setup Defaults
F10 Save and Exit
5