(5) Remove the screw from the scanner motor and take off the motor from the scanner drive unit.
Reassembling Notes
• When securing the scanner motor to the scanner drive unit, face the motor connector up as
shown above.
• Before putting the scanner drive unit into the top cover, make sure that the stopper of bushing L
("a" in Figure A given on the next page) faces up when viewed from the top. Then move
bushing L to the right to fit it in the cutout provided in the top cover.
• Before securing the scanner drive unit to the top cover with two screws, set the document
ejection roller ASSY into place.
4 -2 2