Gigabyte GA-MA790FX-DQ6 User Manual page 81

In the following procedure, we'll create RAID 0 as an example.
1. Under the RAID Mode section, press the Spacebar to select RAID 0.
2. Set the Stripe Block size. 64 KB is the default.
3. Under the Drives Assignments section, press the up or down arrow key to highlight a drive.
4. Press the Spacebar or <Y>to change the Assignment option to Y. This action adds the drive to the
disk array. The Total Drv section will show the number of disks assigned.
5. Press <Ctrl>+<Y> keys to save the information. The window below will appear.
6. Press <Ctrl>+<Y> to set the capacity of the RAID array or press other keys to set the array to its
maximum capacity.
7. After the creation is complete, the screen will return to Define LD Menu where you will see the
newly-created array.
8. Press <Esc> to return to Main Menu and press <Esc> again if you want to exit the RAID BIOS
utility.
View Drive Assignments
The View Drive Assignments option in the Main Menu displays whether drives attached to the ATI
SB600 controller are assigned to a disk array or are unassigned. Under the Assignment column, drives
are labeled with their assigned disk array or shown as Free if unassigned.
FastBuild (tm) Utility (c) 2006 ATI Technology, Inc.
Channel:ID
1:Mas WDC WD800JD-22LSA0
Extent
2:Mas WDC WD800JD-22LSA0
Extent
[ ] Up [ ] Down
Press Ctrl-Y to Modify Array Capacity or press any
other key to use maximum capacity...
Figure 6
[ View Drives Assignments
Drive Model Capacity (MB)
1
1
[ Keys Available]
[ESC] Exit
Figure 7
- 81 -
]
Assignment
80026
79959 LD 1-1
80026
79959 LD 1-2
]
Appendix